4
To adopt display units to the different countries and regions, its posiible to select following units:
1. Volume
a. Litres
b. Galons E (UK)
c. Galons U (USA).
2. Speed
a. Km/h (automatically Kilometers as distance units are selected)
b. Knots (automatically Nautic Miles as distance units are selected)
Changing of units is possible when left button is pressed and holded down while powering the device.
At that moment the upper display is showing current units, which could be changed by short pressing of
the left button. In the left bottom display, appropriate units ikons are then visible ( „l” or Gal”). Changes
are possible within closed loop: Litr, Gal E, Gal U and Litr again. When right volume units are selected,
press both buttons together to switch to speed units. Upper display is showing SPEE, and right bottom
display is showing Km/h or Kts icon. Short pressing of the right button is changing this icon alternately.
Having both units right selected, press both buttons together to save the settings and go back to the
main screen.
17. SETTING OF UNITS
18. SETTING EVERAGING TIME (FLOW)
If to big fuel flow fluctuation are obeserved, its necessery to increase fuel flow everaging time. When
left display is switched to km/l readings, press and hold left button for ca. 5 sek. Then on the top of
screen you will see PErI sign and the left disply begin to blinkshowing current value of everaging time
(5 SEC). Using buttons you can increase this value up to 40sec, however we suggest to set value
to times bigger then previous one, f. ex. 10sec. To save settings press both buttons shortly together.
If new settings are still unsatisfactory, you can try to set another value again.
21
20
These functions allow viewing of several recorded data such as:
These amounts are recorded in real time in the counters memory and are available until
clearing the counters. Since the reset, the counting of the parameters begins again. Resetting the counters is
password protected to hinder the possibility of erasure by unauthorized persons.
Entering into the recorded data is done by selecting on the upper screen Mothour (MTH) option and holding at this
moment both buttons together for min. 5 seconds.
Data on the upper screen will then switch to the Dist, and in the lower left corner is visible
Total distance traveled since the installation of the device or clearing the counters. Other data appear on the screen
after successive pushes of each button: switch left turn: Dist, EFFI, Used, FLO and back Dist etc . and the right HIGH
USUA.of
Back to normal display - after a short pressing of both buttons.
To delete records (all counters at the same time), press and hold both buttons simultaneously for minimum 5 seconds.
You will then see on the top screen PASS word. Using the buttons wright down the number 222. Right button
increases the value of the displayed number while the left button decreases (holding the button longer, increase the
speed of value changes).
After setting the number 222, hold both buttons simultaneously for minimum 5 seconds.
On the upper display will then appear sign „donE” and from that moment all data are set to zero and the device will
start counting all the parameters again.
1. DISt - total travel
2. USEd -
3. EFFI - everage fuel economy
4. FLO - everage fuel consumption
5. HIGH - max. recorded speed
6. USUA - everage speed
total fuel consumtion
19. ADDITIONAL FUNCTIONS (Data log)
To Previous Page
Loading...
Need help?
General