Fluance Ai41 User Manual 13
Volume Adjustment
Adjusting Source LED Brightness
EQ Adjustment
Turn the Control Knob or use the Remote to increase or decrease volume.
Use the LED Brightness Button on the Remote to cycle between 100%, 25%, and OFF
brightness levels.
Use the Bass/Treble buttons on the Remote to adjust each from -5 to +5.
LED Behavior:
Red (Flash 2x) – Bass/Treble Set to -5 or +5
RCA: Green (Flash 2x) – Bass/Treble set to 0*
Optical: White (Flash 2x) – Bass/Treble set to 0*
Bluetooth: Blue (Flash 2x) – Bass/Treble set to 0*
*NOTE: The Status LED will ash the input color when Bass/Treble is set to 0.
NOTE: When set to OFF, the LED will turn on for 5 seconds when power is turned on or
new Source is selected, before turning off again.
To Next Page
Loading...
