FLUID COMPONENTS INTL APPENDIX B - GLOSSARY
Model ST98 Flow Meter B - 4 Doc. No. 06EN003291 Rev. A
NUMBER Menu Function.
S/N and CO No. Only the factory has access to this area.
K. CONSTANTS SETUP Menu Function.
Parameter Definitions See the parameters in Menu Function D.
L. CALIBRATE OUTPUTS Menu Function.
(U)p (P)down Increases or decreases the DAC count.
(F)fast/slow This controls the speed of the DAC counting.
M. MIN/MAX A/D LIMITS Menu Function.
Max A/D High end cut-off A/D number. Prevents false low flow readings.
Min A/D Low end cut-off A/D number. Prevents false high flow readings.
N. SOFTWARE RESET Menu Function.
Software Reset Resets instrument without removing power.
O. SELECT SENSOR
HEATER CURRENT Menu Function.
xxxLO Choosing xxxLO sets software flags to show user if flow values are out of range.
xxxMD Choosing xxxMD does not set any software flags.
P. RECONFIGURE
THE FC88 UNIT Menu Function.
FC88 Reset Re-configures the FC88 so it will function properly in conjunction with the ST98.
R. A/D CALIBRATE
RESISTANCE Menu Function.
A/D Delta-R The difference between the RTD resistances as used by the A/D converter.
A/D Ref-R The reference RTD resistance as used by the A/D converter.
r = xxx A/D Delta-R resistance
R = xxx A/D Ref-R resistance.
S. AUTO SCALE Menu Function.
Auto Scale ON Always on.
T. NORMAL OPERATING
MODE Menu Function.
U. DISPLAY TOTAL
FLOW TIME Menu Function.
Time Time in minutes since the last reset
Reset Resets time to zero.
V. OUTPUT MODE
SELECT Menu Function.
Output Displays the selected instrument output (4-20 mA, 0-5 VDC, 0-10 VDC, 1-5 VDC).
W. TOTALIZER MODE Menu Function.
Totalizer is The Totalizer can be toggled on or off. If it is on, the results are displayed on the
second line of the normal operating mode window.
Reset Totalizer The Totalizer can be reset to 0 with this command.
During Powerup The Totalizer can be automatically reset each time power is applied to the
instrument.
To Next Page
Loading...
