FlowCam® 8000 Series Dynamic Imaging Particle Analyzer
Warnings
Before operating your FlowCam 8100 or 8400 analyzer, read this guide carefully to prevent damage to
humans, animals, integrated devices, and connected devices. Always follow local safety rules. The
instrument should be verified for safe operation following normal use, maintenance, and any factory
service activities. Failure to use this instrument in the manner specified in this guide may impair safety
features and nullify operator protection.
Laser Precautions
• The FlowCam 8400 analyzer contains an
embedded Class 3 laser within its housing. Under
normal operating conditions, the housing and
other protective features prevent the emission of
laser light outside the analyzer. To avoid the
possibility of any laser light exposure, ensure that
you follow all operating instructions and that the
analyzer’s doors and housings remain closed
while it is operating.
• Operating the FlowCam 8400 analyzer with
protective housing or doors that are damaged or
otherwise not in good operating condition may
expose the user and others to laser radiation. If
laser light is observed or detected, discontinue
use of the product immediately and contact Fluid
Cautions
To reduce the risk of electric shock, do not remove any protective covers.
During operation of the FlowCam analyzer, the syringe pump/barrel can move
unexpectedly and without warning. Keep all body parts clear of this area.
Safety Precautions
• To reduce the risk of serious personal injury or equipment damage, never remove the inner
panels of the FlowCam analyzer.
• Beware of electrical shock hazards. To prevent the risk of electrical shock or fire, do not locate
the instrument in wet or unsafe laboratory conditions. Do not touch any damaged, non-isolated
electrical parts.
To Next Page
Loading...
Need help?
General
