Fluid 1607001 - Initial Settings and Configuration; Common Setup Procedures; System and TV Setup

12
Initial Settings
Choose your preferred settings for your player. Once the initial settings are done
they are retained in the memory of the player until otherwise modified.
COMMON PROCEDURES FOR INITIAL SETTINGS
1. Press SETUP button.
2. Use the navigation buttons to select the item you want to modify, press OK
button to confirm. Use the navigation buttons to make changes. Press OK
button to confirm the setting.
3. Use navigation buttons to switch to another setting on the main setting page.
4. Press SETUP button to exit main setting page.
1. SYSTEM SETUP
1.1 TV SYSTEM - used to select the TV mode.
Please select this option as per your TV set.
1.2 LCD MODE - used to select the LCD MODE.
Options: 4:3 16:9
1.3 TV TYPE - used to select the TV scan mode, please set as per your TV set.
Options: 4:3PS : Normal Pan & scan mode
4:3LB : normal Letter box mode
16:9: 16:9 wide screen mode
1.4 PASSWORD
- input password to unlock the system. The steps are as follows:
1.4.1 Enter SYSTEM SETUP, select the PASSWORD item by scrolling with the down
navigation button, and then press the right navigation button to select the input box.
1.4.2 Input user’s password “0000” to unlock it, in this case, select the input box again
to change the password by inputting a new four digit number and then press OK button
to confirm. When the password is changed, you are required to input the new one to
unlock the system.
1.4.3 If you forget your new password, use the supervisor’s password to unlock it.
NOTE: If wrong password was input in unlock status, the system will lock.