Fluke Calibration 8588A - Example: Direct Product to Controlling Computer Connection Configuration

8588A/8558A
Remote Programmer's Manual
8
Subnet Mask
Default: 255.255.255.000
Port
Default: 3490
Remote Interface
Default: Computer, can be set to Terminal
EOL
Default: LF can also be set to CR CRLF
Example: Direct Product to Controlling Computer Connection Configuration
Product configuration
DHCP: OFF
Ethernet IP Address: 192.168.0.250
Gateway: 192.168.001.001
Subnet Mask: 255.255.255.000
Port: 3490
Remote Interface: Computer
EOL: LF
Controlling computer configuration:
1. Right click on the Windows Start Icon and select Network Connections
2. Select Network and Sharing Center.
3. Select Change adapter settings.
4. Right click on the interface and select Properties.
5. Highlight Internet Protocol Version 4 (TCP/IPv4) and select Properties.
6. On the General tab, select Obtain an IP address automatically.
7. Select Alternative Configuration tab.
8. Select User Configured.
IPv4 Address: 192.168.0.250
Subnet mask: 255.255.255.0
Default Gateway: 192.168.0.1
9. Check that communications can be established:
Write *IDN?
Read the response
Clear registers
Write: *CLS;*RST
10. Before you proceed, set the event and status registers as required.