Fluke Calibration 8588A - Table 11. SYSTem Subsystem (cont.)

To Next Page

To Previous Page

8588A/8558A

Remote Programmer's Manual

Table 11. SYSTem Subsystem (cont.)

Keyword Description

:TEMPerature? Returns internal temperatures in form x,y

x = temperature in degrees Celsius measured on the

analogue assembly

x = temperature in degrees Celsius measured on the Digital

assembly

:COMMunicate:ENABLE

USB|GPIB | ENET

Selects active remote port (no query available for this

command)

:COMMunicate:GPIB:ADDress

<value>

Set GPIB address

:COMMunicate:GPIB:ADDress? Query the GPIB bus address

:COMMunicate:LAN:CONTrol <port> Set or query the port

:COMMunicate:LAN:CONTrol?

:COMMunicate:LAN:DHCP[:STATE]

Turn DHCP ON or OFF

:COMMunicate:LAN:DHCP[:STATE]?

:COMMunicate:LAN:GATeway

<ipaddress> is in the form xxx.xxx.xxx.xxx, i.e.

192.168.1.190

:COMMunicate:LAN:GATeway? Returns the address

:COMMunicate:LAN:IPADdress

:COMMunicate:LAN:IPADdress?

:COMMunicate:LAN:MAC? Returns the MAC address

:COMMunicate:LAN:SMASk

<ipmask> is in the form xxx.xxx.xxx.xxx, i.e. 255.255.255.0

:COMMunicate:LAN:SMASk? Returns the IP mask.

Note (1): Only a valid command when the Active Port is Ethernet. The commands cause an error if the

Active Port is GPIB or USB.