PN 5382413 (English)
10/2022
©2022 Fluke Corporation. All rights reserved. Specifications are
subject to change without notice. All Product names are
trademarks of their respective companies.
17xx Clamp Adapter
BNC Adapter for Clamps
Instructions
Introduction
The 17xx Clamp Adapter is an accessory for the 17xx-series
of Power Quality Analyzers. Use the adapter to connect the
current clamp with the BNC connector to the 17xx Analyzer.
This adapter is ready-to-use for all clamps with a ratio of
1 mV/A. Select the adapter version depending on the voltage
output of the clamp:
Maximum 1 V: Supports clamps with a range from
0.2 A RMS to 1000 A RMS or up to ±1500 A DC
Maximum 2.8 V: Supports clamps with a range from
4 A RMS to 2800 A RMS or up to ±4000 A DC
See Supported Clamp Models for the required measurement
configuration on the 17xx Analyzer and a clamp with a ratio
other than 1 mV/A.
Connector to 17xx Analyzer
Label with maximum clamp output voltage
BNC connector to Clamp cable
FLUKE 17XX
Clamp
A
d
a
p
ter
3
1
2
To Next Page
Need help?
General
