Clamp Meter
Safety Information
3
• Hold the Product behind the tactile barrier. See The Clamp Meter,
item .
• Do not exceed the Measurement Category (CAT) rating of the lowest
rated individual component of a Product, probe, or accessory.
• Do not measure current while the test leads are in the input jacks.
• Do not use the Product around explosive gas, vapor, or in damp or wet
environments.
• Limit operation to the specified measurement category, voltage, or
amperage ratings.
• Do not work alone.
• Do not apply more than the rated voltage, between the terminals or
between each terminal and earth ground.
• Comply with local and national safety codes. Use personal protective
equipment (approved rubber gloves, face protection, and flame-resistant
clothes) to prevent shock and arc blast injury where hazardous live
conductors are exposed.
• Replace the batteries when the low battery indicator shows to prevent
incorrect measurements.
To Next Page
Loading...
