323/324/325
Users Manual
4
• Do not apply more than the rated voltage, between the terminals or
between each terminal and earth ground.
• Comply with local and national safety codes. Use personal protective
equipment (approved rubber gloves, face protection, and flame-
resistant clothes) to prevent shock and arc blast injury where
hazardous live conductors are exposed.
• Replace the batteries when the low battery indicator shows to prevent
incorrect measurements.
• The battery door must be closed and locked before you operate the
Product.
• Measure a known voltage first to make sure that the Product operates
correctly.
• Remove all probes, test leads, and accessories that are not necessary
for the measurement.
• Only use probes, test leads, and accessories that have the same
measurement category and voltage rating as the Product.
• Keep fingers behind the finger guards on the probes.
To Next Page
Loading...
