Fluke 5520A - Where to Go from here

5520A
Getting Started
4
Unit Under Test
PC or Terminal
5520A
5520A
SERIAL 1 FROM HOST port
COM port
RS-232 Remote Operation using the
SERIAL 1 FROM HOST port
PC or Terminal
SERIAL 1 FROM HOST port
COM port
SERIAL 2
TO UUT port
RS-232 Remote Operation using the
SERIAL 1 FROM HOST and
SERIAL 2 TO UUT ports
nn031f.eps
Figure 2. RS-232 Remote Connections
Where to Go from Here
To locate specific information in the Operators Manual (provided as a pdf file on the CD-
ROM) refer to the following list:
• Unpacking and setup: Chapter 2, “Preparing for Operation”
• Installation and rack mounting: Chapter 2, “Preparing for Operation,” and the rack
mount kit instruction sheet
• AC line power and interface cabling: Chapter 2, “Preparing for Operation”
• Controls, indicators, and displays: Chapter 3, “Features”
• Front panel operation: Chapter 4, “Front Panel Operation”
• Cabling to a UUT (Unit Under Test): Chapter 4, “Front Panel Operation”
• Remote operation (IEEE-488 or serial): Chapter 5, “Remote Operation”
• Calibrating an Oscilloscope: Chapter 8, “Oscilloscope Calibration Options”
• Accessories to the 5520A Calibrator: Chapter 9, “Accessories”
• Performance Specifications: Chapter 1, “Introduction and Specifications”