Fluke 5520A - Page 8

5520A
Getting Started
2
Features of the 5520A Calibrator include the following:
• Automatic meter error calculation.
• X and D keys that change the output value to pre-determined cardinal values
for various functions.
• Programmable entry limits that prevent invalid amounts from being entered.
• Simultaneous output of voltage and current, up to an equivalent of 20.9 kW.
• Pressure measurement when used with Fluke 700 Series pressure modules.
• 10 MHz reference input and output. Use this to input a high-accuracy 10 MHz
reference to transfer the frequency accuracy to the 5520A, or to synchronize one or
more additional 5520As to a master 5520A.
• Simultaneous output of two voltages.
• Extended bandwidth mode outputs multiple waveforms down to 0.01 Hz, and sine
waves to 2 MHz.
• Variable phase signal output.
• Standard IEEE-488 (GPIB) interface, complying with ANSI/IEEE Standards
488.1-1987 and 488.2-1987.
• EIA Standard RS-232-C serial data interface for printing, displaying, or transferring
internally stored calibration constants, and for remote control of the 5520A.
• Pass-through RS-232-C serial data interface for communicating with the Unit Under
Test (UUT).