Remote Commands and Syntax
Commands 6
6-11
Table 6-4. Command Summary by Function
Error Mode Commands
ADJOUT? Returns the adjusted output magnitude and frequency
ERR_REF Selects the denominator for UUT error calculations.
ERR_REF? Returns the denominator used to compute UUT error.
INCR Increments or decrements the output
MULT Multiplies the reference by a value and establishes a new reference
NEWREF Establishes a new reference
OFFSET Sets and enables or disables an offset
OFFSET? Returns the value of the present offset
OLDREF Sets the output to the present reference
OUT_ERR? Returns the UUT error computed by the Calibrator
REFOUT? Returns the value of the present reference
SCALE Activates and deactivates scaling
SCALE? Returns scaling information
SCAL_ERR? Returns the value of the scale error if scaling is active
Calibrator Configuration Commands
BRIGHTNESS Sets the brightness of the GUI display.
BRIGHTNESS? Returns the brightness setting.
BTYPE Selects the amplifier type for voltage or current boost
BTYPE? Returns the amplifier types set for voltage and current boost
CLOCK Sets the clock/calendar
CLOCK? Returns the setting of the clock/calendar
CUR_POST Selects the active binding post for non-boosted current output
CUR_POST? Returns the active binding post for non-boosted current output
EMULATE Partially emulates a 5700A or 5720A over the remote interface.
EMULATE? Returns the state of emulation as set by the EMULATE command.
EXTGUARD Opens and closes an internal connection between GUARD and LO
EXTSENSE Opens and closes an internal connection between SENSE and OUTPUT
FORMAT Restores calibration constants and setups to factory defaults
LIMIT Sets positive and negative output limits
LIMIT? Returns the programmed positive and negative output limits
*LRN? Returns a list of commands that would duplicate the present state
RANGE? Returns the present output range
RANGELCK Locks in the present range, or selects autoranging
LCOMP_52120 Sets inductance compensation for attached 52120As
POST_52120 Sets the output terminals for attached 52120As
XFERCHOICE Sets whether the choice to turn ac/dc transfers off is given on the front
panel GUI for ac V outputs.
XFERCHOICE? Returns whether the choice to turn ac/dc transfers off is given on the front
panel GUI for ac V outputs.
To Next Page
Loading...
