Appendices
Fault Codes A
A-5
800-Level Faults: Executive
800 Wideband Module Needed
801 Amplifier Not Selected or Connected
802 Amplifier Must Remain On For This Output
803 Over Limits Of Locked Range
804 Under Limits Of Locked Range
806 Invalid Date
807 Invalid Time
808 DC dBm Not Allowed
809 Ext Ref Value Out Of Range
810 Bad Edit Digit Movement
811 Not Wideband Units
812 Cannot Set Frequency With Ohms
813 Bad Units
814 Wrong Polarity For Limit
815 Outside Entry Limits
816 Magnitude Too Large For Calibrator
817 Magnitude Too Small For Calibrator
818 Frequency Too Large For Calibrator
819 Frequency Too Small For Calibrator
820 Calibrator Cannot Source That Value
821 V Limit Outside Calibrator Ability
822 I Limit Outside Calibrator Ability
823 Cannot Adjust Frequency To <= 0 Hz
824 Offset Not Allowed Now
825 Scale Not Allowed Now
826 Ohms Reading Set Too High
827 Ohms Reading Set Too Low
828 Cannot Use External Sense Now
829 Cannot Use Phase Shift Now
830 Cannot Use Phase Lock Now
831 Cannot Use 2-Wire Comp Now
832 Could not Do Default Wideband Output
833 Bad Selector For Set/Get Item
834 Cannot Boost This Output Mode
To Next Page
Loading...
