Fluke 700G Series - Page 3

Manual Supplement 700G Series User
2 5/16
Change #5, 291
On page 2, replace the Warning section with:
XhW Warning
To prevent possible electrical shock, fire,
explosion, or personal injury:
• Read all safety information before you use the
Product.
• Carefully read all instructions.
• Avoid any actions that can generate an
electrostatic charge. Electrostatic discharge is an
explosion hazard.
• Do not rub the non-metallic parts of the enclosure
(display overlay or holster) with a dry cloth. The
friction can create an electrostatic discharge.
• Clean the Product only with a damp cloth.
• Only assemble and operate high-pressure
systems if you know the correct safety
procedures. High-pressure liquids and gases are
hazardous and the energy from them can be
released without warning.
• Use the Product only as specified, or the
protection supplied by the Product can be
compromised.
• Do not use the Product around explosive gas,
vapor, or in damp or wet environments.
• Do not use the Product if it operates incorrectly.
• Do not use the Product if it is damaged.
• Disable the Product if it is damaged.
• The battery door must be closed and locked
before you operate the Product.
• Remove the batteries if the Product is not used
for an extended period of time, or if stored in
temperatures above 50 °C. If the batteries are not
removed, battery leakage can damage the
Product.
• Replace the batteries when the low battery
indicator shows to prevent incorrect
measurements.
• Repair the Product before use if the battery leaks.
• Be sure that the battery polarity is correct to
prevent battery leakage.
• Substitution of components can impair suitability
for hazardous locations.