Battery
Warning
To prevent electrical shock, unclamp the Probe from any
conductor, and disconnect the Scopemeter test tool or any
other measurement device before you install or replace the
battery.
Before the first use, install the battery. See Figure 2.
To install the battery:
1. Unclamp the Probe from any conductor and disconnect the
ScopeMeter test tool or any other measurement device.
2. Make sure that the Probe is in the OFF position.
3. Locate the battery cover on the handle and loosen the screw with a flat-
blade screwdriver.
4. Slide the battery cover away from the Probe.
5. Install the battery (IEC 6LR61). Arrange the battery leads so that they
are not pinched between the handle bottom and the battery cover.
6. Reinstall the battery cover and secure the screw.
Figure 2. Battery Installation
Warning
To prevent possible electrical shock, fire, or personal injury,
replace the batteries when the low battery indicator shows to
prevent incorrect measurements.
+
80i-110s.book Page 4 Monday, December 5, 2016 12:12 PM
To Next Page
Loading...
