8505A
STORE
When
the multimeter is in the Calibration Mode (AVG/(CAL)
annunciator flashes),
the
(CAL DATE) push button is used to enter six digits which either
denote the date or
identify the multimeter by
number. Refer
to
Calibration
Mode later in this section.
The
SCALING
push button
can be used to
toggle into/out of the Scaling mode without
affecting
any scaling value already
stored. Either of
the
following two
methods can
be
used to store
a
new
scaling factor and
enable the Scaling mode:
NOTE
Verify that the
displayed value is the desired
scaling value. Any mathematic
operations
(SCALING,
EXT REF, OFFSET) already
in effect must
be
cancelled
if the actual
measurement
is desired as the scaling
value. To cancel any
of these modes, toggle
SCALING, EXT REF,
or OFFSET and verify
that the respective annunciators
are dark.
t. Use the following sequence to store the display as a scaling factor:
STORE SCALING
2. Numeric entry
scaling factors must be programmed using the following
procedure:
STORE (numerics) SCALING
With
either
method, the Scaling mode is entered with
the initial use of the SCALING
button.
The (CAL COR) push button is
used
when storing calibration
factors for
each
function
and range, or when recalling uncorrected readings. Refer
to
Calibration
Mode later in
this
section.
STORE is
used
as
a
first step in programming certain
measurement parameters,
mathematic operations, or special operations. ST ORE is the only
push button that can
activate the numeric entry keys.
The
multimeter prompts the second step
by displaying
Following is a
list of STORE operations:
Measurement Parameters:
0-17
SAMPLE
STORE
0,1,
2,
3
or
c
,.
T
_
D
2-12
Figure
2-2.
Front Panel Push Buttons
(cont)
To Next Page
Loading...
