Fluke 8845A User Manual

Contents (continued)
iii
Physical Layer Wiring Schemes Supported by the Meter ............................. 106
Network Interconnection Devices ................................................................. 107
Basic Network Packet and Frame Contents .................................................. 107
IP Addresses and Segmented Networks ........................................................ 108
TCP/IP Protocol Stack................................................................................... 110
Introduction........................................................................................................ 113
Device Dependent Command Set ...................................................................... 113
Calibration Commands ...................................................................................... 113
Dn (Display Commands) ................................................................................... 114
Gn (Get Commands).......................................................................................... 114
Tn (Trigger Mode Commands).......................................................................... 114
Wn (Terminator Commands)............................................................................. 114
Numeric Entry Command.................................................................................. 114
Talk-Only Mode ................................................................................................ 114
Ranging in 8842A Emulation Mode.................................................................. 114
Operational Differences..................................................................................... 115
Appendices
A Error Codes ................................................................................................ 95
B Fluke 45 Emulation Limitations.................................................................. 103
C Network Consideration................................................................................ 105
D Fluke 8842A Emulation Limitations........................................................... 113

Fluke 8845A Specifications

General

Frequency Range	3 Hz to 300 kHz
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	100 μA to 10 A
Resistance Range	100 Ω to 100 MΩ
Resistance Accuracy	0.01 %
Display	5.5 digit
Connectivity	RS-232
AC Current Range	100 μA to 10 A
Frequency Accuracy	0.01 %
Dimensions	88 mm
AC Voltage Accuracy	±(0.06% + 0.03%)
Power Supply	100 V to 240 V AC, 47 Hz to 63 Hz