Fluke 9040 - Replacing the Fuse (9040 UK only)

9040
Users Manual
10
Replacing the Fuse (9040UK only)
XW Warning
For safe operation and maintenance of the product:
• Use only specified replacement fuses. See Specifications section.
• Before you replace the fuse, disconnect the accessory (cable or probe)
at both ends.
To replace the fuse:
1. Check the fuse using a simple continuity test.
2. Hold the probe in front of the finger guard and unscrew the tip in a counter-
clockwise direction.
3. Remove the defective fuse from the fuse holder.
4. Insert a new fuse in the fuse holder and reassemble the probe.