Fluke 9140 - Linefeed

7.8.1.2 Linefeed
The final parameter in the serial interface menu is the linefeed mode. This pa
-
rameter enables (on) or disables (off) transmission of a linefeed character (LF,
ASCII 10) after transmission of any carriage-return. The linefeed parameter is
indicated by,
LF
Serial linefeed parameter
Press “SET” to access the linefeed parameter.
LF= On
Current linefeed setting
The mode may be changed using “UP” or “DOWN” and pressing “SET”.
LF= OFF
New linefeed setting
9140 Dry-well Calibrator
User’s Guide
32