Fluke 9140 - Stabilization and Accuracy; Figure 7 Typical Heating Rate; Figure 8 Typical Cooling Rate

WARNING: DO NOT remove inserts when heating or when the unit is
hot.
9.2.3 Stabilization and Accuracy
The stabilization time of the dry-well calibrator will depend on the conditions
and temperatures involved. Typically the test well will be stable to 0.1°C within
5 minutes of reaching the set-point temperature as indicated by the display. Ul
-
41
9 Test Probe Calibration
Dry-well Characteristics
350
300
250
200
150
100
Block Temperature °C
24
6810
12
Ambient
Time in Minutes
Figure 7 Typical Heating Rate
350
300
250
200
150
100
Block Temperature °C
24
6810
12
Ambient
Time in Minutes
Figure 8 Typical Cooling Rate