Parts and Controls
Back Panel
Parts and Controls
This section describes the exterior features of Metrology Wells.
Back Panel
The following are found on the back of Metrology Wells (see Figure 2).
Power Cord Plug (1)
The power supply cord attaches to the back pan
e
l. Plug the cord into an AC mains supply
appropriate for the voltage range as specified in the specifications tables.
Power Switch (2)
The power switch is located on the power entry module of the instrument at the bottom left of the
back
pa
nel.
Serial Connector (3)
The serial connector is a 9-pin subminiature D type locate
d
on the back panel. The serial (RS-232)
interface can be used to transmit measurements and control the operation of Metrology Wells.
Fan (4)
The fan is necessary to keep the internal components cool. Always make sure air can flow freely
un
de
rneath and around the instrument.
Front Panel
The following are found on the front of Metrology Wells (see Figure 3 on page 21).
Display (1)
The display is a 320 x 240 pixel monochrome graphics LCD device with a bright CCFT backlight.
The c
o
ntrast can be adjusted from the main screen using the 2 or 1 buttons on the front panel.
The display is used to show current control temperature, measurements, status information,
operating parameters, and soft key functions.
Soft Keys (2)
The soft keys are the four buttons immediately below the display (labeled F1 to F4). The functions
of the s
o
ft keys are indicated on the display above the buttons. They may change depending on the
menu or function that’s selected.
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30
To Next Page
Loading...
