Fluke B Series - Page 15

5100B
On page 8-31:
Add the following column to the end of the logic table:
on page a-34,
make the following changes to the logic table:
FROM: AWX OUTPUT I
I
I 1 I --+-- I
I’,I I, I
TO:
AC BOOST !
DC BOOST 1
On page l-5:
CHANGE: 0.2 V to I
1.99999 v I
TO: 0.2vto I
1.99999 v I
CHAHGE: 20 mV to ;
199.999 rnVl
I
TO:
20 mv to I
199.999 mvi
10 UP i 2 kohm/lOOO pF
I
max.
10 uV
1 2 kohm min./1000 PF
I max.
1 uv
1 25 mA ,from,
1, ,50 ohm souroe
1 ,’ resistance.
1 uv
i Limited by 50 ohm
source resistance.
I'1 IO IO I
I, 1 I 1 I ,'I I
Add the following note to <h'&' bottom"of the ACCUR'ACP coliU,mn:
Note "
"RANCrEW in accuracy s,tateme,nt is 20V ~
for 50 ohm override.
CHARGE 115 - 13422
on page l-4,
under Load Regulation:
CHAIIGE: INTERNAL SENSE:
Same as external except max. full load is 400 ohm.
TO:
INTERNAL SENSE: (At output terminals) Same as external except max.
full load is 400 ohm.
8/80
6