On page I-5:
Under "Transieat Recovery Time":
FROM:
2 seconds to settle within 100 ppm for . . .
TO: 2 seconds to settle within 100 pgm of final value for . . .
Under "INTERNAL SENSE":
FROM: Same as external except voltages less than 0.2V have a
load
regulation expressed as an output impedanae of 50 ohms.
TO: (At output terminals)
Same
as external exc'ept voltages less
than 0.2V have a load regulation expressed as an output
impedanae of 50 ohms.
On page l-7:
Under "Transient Recovery Time":
FROM:
4 seconds to settle within 0.02% for current . . .
TO: 4 seconds to settle within 0.2% of final value for current . . .
On page l-9:
Under "Transient Recovery Timan:
FROM: 2 seconds to settle within 500 ppm for . . .
TO:
2 seconds to settle within 500 ppm
of
final value for . . .
CHANGE 516 . 13524
on page 5-4:
DELETE: MP6:CARD PULLER~170951~895361170951~1
DELETE:
~~281
AOLDER,
COMPONENT (RUBB~ER)l104794l98159l2829-115-311
On page 5-8:
Delete all reference of MP6 and
~~28.
CBABGE
t17 - 13525
On page 5-4:
CHANGE: MP23tFRAME, FILTER~421750~895~36l421750Il
TO:
MP231FRAME, FILTER15T69591895361576959ll
CHANGE #I8 - 13535
Rev.- H, Al4 Analog Control PCB
On page 5-75:
Change the TOT PTY of PIO, FROM
CBAAGE: Q62lXSTR, FET, N-CHANNEL
TO: 462lXSTR. FET, N-CHANNEL
137007218953613700r2lREF
, HI-VOLT1393314(17856~5T282412
CHANGE: MP221FILTER ELEMENT
TO:
MP22,lFILTER ELEMENT
Amy. (51OOA,-40501)
8/80
To Next Page
Loading...
