4 - 96 COMMAND REFERENCE
SYSTem:BEEPer
SYSTem:BEEPer:STATe
Syntax:
SYSTem:BEEPer
SYSTem:BEEPer:STATe <Boolean>
Query form:
SYSTem:BEEPer:STATe?
Response:
0 | 1
0 Beeper disabled.
1 Beeper enabled.
Description:
The SYST:BEEP command causes a beep of about 1 second to be generated by
the instrument, even if the SYSTem:BEEPer:STATe is OFF.
The SYST:BEEP:STAT command enables or disables the beeper of the
instrument. If the STATe is turned OFF, no instrument condition will cause an
audible beep to be emitted.
After a
*
RST command, the beeper is turned on.
Example:
Send
→
SYSTem:ERRor? Reads the error queue.
Read
← error_number,"error_description"
IF error_number = 0 THEN
send
→ SYSTem:BEEPer Beeps on error.
END IF
Send
→ SYSTem:BEEPer:STATe OFF Turns automatic beeper off.
Send
→ SYSTem:BEEPer Generates a beep.
Front panel compliance:
The SYSTem:BEEPer:STATe command is the remote equivalent of the front
panel BEEP ON OFF option of the UTILITY menu.
To Next Page
Loading...
