Fluke i400 Calibration Information

®
PN 2414311 March 2005 Rev.1, 10/05
© 2005 Fluke Corporation. All rights reserved. Printed in U.S.A.
1
i400
AC Current Clamp
Calibration Information
Introduction
XWWarning
To avoid electric shock or injury, do not perform the performance tests or
calibration procedures unless you are qualified to do so.
The information provided in this manual is for the use of qualified personnel
only.
The i400 Calibration Information provides the information necessary to verify the performance of the
Fluke i400 AC Current Clamp, hereafter known as the Current Clamp.
The following information is included in this document:
• Safety Information and Electrical Symbols
• Specifications
• Maintenance
• Performance Tests
• User-Replaceable Parts
• Warranty Statement
See the i400 Instruction Sheet for complete operating instructions.
Contact Information
To contact Fluke, call:
USA: 1-888-44-FLUKE (1-888-443-5853)
Canada: 1-800-36-FLUKE (1-800-363-5853)
Europe: +31 402-675-200
Japan: +81-3-3434-0181
Singapore: +65-738-5655
Anywhere in the world: +1-425-446-5500
USA Service: 1-888-99-FLUKE (1-888-993-5853)
For additional information about Fluke, its products, and services, visit Fluke’s web site at:
www.fluke.com
To register this product, go to register.fluke.com

Fluke i400 Specifications

General

Current Range	1 A to 400 A AC
Output Sensitivity	1 mV/A
Battery Type	9 V alkaline
Maximum Conductor Size	32 mm diameter
Safety Category	CAT IV 600 V
Operating Temperature	-10 °C to +50 °C
Storage Temperature	-40 °C to 60 °C