Need help?Do you have a question about the Fluke NetTool II Series and is the answer not in the manual?
General| Model | NetTool II Series |
|---|---|
| Power over Ethernet (PoE) Detection | Yes |
| Cable Testing | Yes |
| Connectivity Testing | Yes |
| Display | Backlit LCD |
| Power Supply | Battery or PoE |
| Interface | RJ-45 |
| Dimensions | 17.8 cm x 8.9 cm x 5.1 cm (7.0 in x 3.5 in x 2.0 in) |
| Weight | 0.45 kg (1.0 lb) |
Diagnose and resolve common network cable issues.
Monitor network traffic for configuration and health information.
Confirm connectivity to network devices like PCs, servers, and printers.
Verify Voice over IP service and monitor call quality.
Detect and measure Power over Ethernet (PoE) voltage and current.
Log and track detected problems from physical to application layers.
Explains the meanings of international electrical symbols found on the tester for safe operation and disposal.
Details on installing alkaline or NiMH batteries and using the AC adapter for power.
Identification of all numbered components on the front panel of the NetTool tester.
Details on Link, Collision/Error, and Utilization LEDs for network status.
Information on CHARGE/PoE LEDs and control buttons like Power, SELECT, and Navigation.
Description of the backlit graphical LCD display for menus and results.
Details on the Left RJ-45, USB, and AC power connectors for connectivity and charging.
How to scroll and page through menus using navigation keys and SELECT.
Procedure to close screens and access configuration menus via navigation.
Explanation of the network diagram shown on the top screen for connection information.
Automatically analyzes the connection at RJ-45 jacks and displays results.
Proves Ping and Application connectivity to servers and key devices.
Displays the Problem log, alerting to detected issues like errors or mismatches.
Lists all key devices and categorizes them by type (servers, routers, printers).
Contains support tools like Health, Protocols, Ping, and Reporter.
Contains additional applications like VoIP and Security if installed.
Select the desired unit of measurement (Feet/Meters) for tests.
Configure the tester to automatically turn off after 10 minutes of inactivity.
Enable or disable charging of NiMH batteries when they are installed.
Procedure to set the tester's internal time and date using navigation keys.
Resets all tester settings to their original factory default configuration.
Instructions for connecting the tester to a single device or network drop.
To Next Page
