Fluke NetTool II Series User Manual

20
AutoTest
When you run AutoTest, the tester searches the RJ-45
connections to determine what it is connected to and
then displays results.
To run AutoTest:
1. Connect the NetTool tester as shown in one of
the network diagrams presented earlier.
2. Turn on the tester.
The AutoTest screen is displayed:
ahn13s.bmp
3. If a device is connected, turn it on.
4. Press SELECT to start AutoTest.

Fluke NetTool II Series Specifications

General

Brand	Fluke
Model	NetTool II Series
Category	Test Equipment
Language	English