4
SimpliFiber Pro Users Guide
Features
GBT01.EPS
: On/off key.
: Selects auto wavelength mode, which is used with a
SimpliFiber Pro meter. The AUTO LED lights. The source’s
signal includes an identifier that tells the SimpliFiber Pro
meter which wavelength to measure.
Press
to change the wavelength. The wavelength LEDs
indicate the wavelength.
: Switches between continuous wave and 2 kHz
modulated output signals.
Use continuous wave mode (CW/2 kHz LED on steady)
for making loss or power measurements with a meter
other than a SimpliFiber Pro meter.
Use the 2 kHz modulated output mode (CW/2 kHz LED
blinking) if locating fibers with a meter other than a
SimpliFiber Pro meter.
Also enables or disables auto power-off. See "Auto Power-
Off".
: Selects FindFiber mode, which is used with a SimpliFiber
Pro meter to help you quickly identify link connections at
patch panels. The ID 1 LED lights if the source is in FindFiber
mode.
To Next Page
Loading...
