To Next PageTo Next Page
Need help?Do you have a question about the Fluke ScopeMeter 190-204 and is the answer not in the manual?
General| Bandwidth | 200 MHz |
|---|---|
| Channels | 4 |
| Sample Rate | 2.5 GS/s |
| Memory Depth | 10, 000 points per channel |
| Safety Rating | CAT III 1000 V / CAT IV 600 V |
| Connectivity | USB |
| Battery Life | 4 hours |
| Input Impedance | 1 MΩ |
| Maximum Input Voltage | 1000 V |
| Operating Temperature | 0 °C to +40 °C |
| Storage Temperature | -20 °C to +60 °C |
| Weight | 2.2 kg |
Procedure to turn on the test tool using the power adapter.
Describes how to connect probes to the test tool's BNC and banana jack inputs.
Using Connect-and-View to automatically optimize settings for unknown signals.
How to display numeric readings for measurements like Hz and Peak-Peak.
Adjusting trigger parameters for stable waveform display.
Procedure to calibrate voltage probes for accurate measurements.
Detailed technical specifications for the oscilloscope.
Specifications for automated measurement functions.
Maximum input voltage limits by CAT rating.
Essential safety measures to prevent injury or damage.
Verification procedures for scope inputs A, B, C, D.
Procedures for verifying meter functions.
Steps for warming up and pre-calibrating the instrument.
Calibration procedure for Input A's LF-HF gain.
Calibrating voltage gain for multimeter functions.
Procedure for calibrating the voltage probes.
Steps to open the instrument and remove the battery.
