Need help?Do you have a question about the Fluke 1503 and is the answer not in the manual?
General| Display type | - |
|---|---|
| Housing color | Grey, Yellow |
| Maximum voltage | 600 V |
| Drop proof up to | 1 m |
| Operating altitude | 0 - 2000 m |
| Auto discharge time | 0.5 s |
| Operating vibration | 2 G |
| Overload protection | Yes |
| Non-operating altitude | 0 - 12000 m |
| Maximum capacitive load | 1 µF |
| Storage temperature (T-T) | -40 - 60 °C |
| Operating temperature (T-T) | -20 - 55 °C |
| Insulation measurement range | 0.01 - 2000 MΩ |
| Insulation test voltage accuracy | 20 % |
| Operating relative humidity (H-H) | 0 - 95 % |
| Insulation measure accuracy (500V) | 1.5 % |
| International Protection (IP) code | IP40 |
| Battery size | AA |
| Number of batteries supported | 4 |
Weight and Dimensions| Depth | 50 mm |
|---|---|
| Width | 100 mm |
| Height | 203 mm |
| Weight | 550 g |
Provides contact information for Fluke support and services.
Describes how to activate special features by holding buttons during power-on.
Explains how to perform AC/DC voltage measurements using the tester.
Details the procedure for measuring earth-bond resistance.
Provides steps for conducting insulation resistance tests.
Explains how to measure PI and DAR for insulation diagnostics.
Describes how to set and use pass/fail limits for insulation measurements.
Outlines the procedure to test the battery status of the tester.
Provides instructions on how to replace the fuse and batteries.
Details the specifications for AC/DC voltage measurement accuracy and range.
Lists the specifications for earth-bond resistance measurements.
Provides detailed specifications for insulation resistance testing.
Lists the specifications required for European labeling according to EN61557.
To Next Page
