Need help?Do you have a question about the Fluke 1507 and is the answer not in the manual?
General| Display type | - |
|---|---|
| Housing color | Grey, Yellow |
| Maximum voltage | 600 V |
| Drop proof up to | 1 m |
| Operating altitude | 0 - 2000 m |
| Auto discharge time | 0.5 s |
| Operating vibration | 2 G |
| Overload protection | Yes |
| Non-operating altitude | 0 - 12000 m |
| Maximum capacitive load | 1 µF |
| Storage temperature (T-T) | -40 - 60 °C |
| Operating temperature (T-T) | -20 - 55 °C |
| Insulation measurement range | 0.01 - 2000 MΩ |
| Insulation test voltage accuracy | 20 % |
| Insulation measure accuracy (50V) | 3 % |
| Operating relative humidity (H-H) | 0 - 95 % |
| Insulation measure accuracy (250V) | 1.5 % |
| International Protection (IP) code | IP40 |
| Battery size | AA |
| Number of batteries supported | 4 |
Weight and Dimensions| Depth | 50 mm |
|---|---|
| Width | 100 mm |
| Height | 203 mm |
| Weight | 550 g |
Essential safety precautions for operating the insulation testers to prevent injury or damage.
Outlines the correct procedure for connecting and disconnecting test leads to the circuit.
Instructions for performing AC and DC voltage measurements with the tester.
Guide to measuring earth-bond resistance, including pre-test checks and procedures.
Steps for conducting insulation resistance tests on de-energized circuits.
Procedure for calculating PI and DAR using insulation resistance readings.
How to set pass/fail limits for insulation measurements using the Compare function.
Provides environmental, safety, and physical characteristics of the testers.
To Next Page
