Fluke 150X Series - User Manual

150X Series
Insulation Testers
Calibration Manual
November 2005 Rev. 2, 11/21 (English)
©2005 - 2021 Fluke Corporation. All rights reserved.
Specifications are subject to change without notice.
All product names are trademarks of their respective companies.

Summary

LIMITED WARRANTY AND LIMITATION OF LIABILITY

Introduction

Safety Information

Basic Maintenance Procedures

Product Cleaning and Testing

Covers cleaning procedures and basic operational tests for the product.

Calibration Adjustment Steps

Calibration Adjustment Procedure

Service and Parts Information

Contact Fluke

General Specifications

Basic Maintenance

Product Cleaning

Instructions for cleaning the product using a damp cloth and mild detergent.

Static Awareness

Battery Testing and Replacement

Display and Backlight Testing

Keypad Test

Disassemble and Reassemble the Tester

Holster Removal

Battery Door Removal

Bottom Case Opening

PCA Removal

Display Removal

LCD Replacement

Tester Reassembly

Required Tools and Equipment

Performance Tests

Voltage Function Testing

Verifies the accuracy of the voltage measurement function using test steps.

Discharge Circuit Test

Insulation Function Testing

Insulation Resistance Accuracy Tests

Insulation Function External Sense

Source Voltage Accuracy Test (R-Nominal)

Source Voltage Accuracy Test (Open Circuit)

I Nominal Test

I Limit Test

Test the Ohm Function

Earth Bond Resistance Accuracy Tests

Tests earth bond resistance accuracy using specified procedures and limits.

2-Ohm Output Current Test

Open Circuit Voltage Test

Calibration Adjustment

Calibration Adjustment Password

Change the Password

Restore the Default Password

Calibration Adjustment Procedure

Service and Parts Information

Fluke 150X Series Specifications

General

Insulation Test Voltages	50 V, 100 V, 250 V, 500 V, 1000 V
Safety Rating	CAT IV 600 V
Type	Insulation Tester
Insulation Resistance Range	0.01 MΩ to 2.0 GΩ
Battery Type	AA
Battery Life	1000 insulation tests (typical)