QuickStart: FLUKE Ti9, Ti10, Ti25, TiRx, TiR, TiR1
© 2011 The Snell Group / 322 N. Main St. / Suite 8 / Barre, VT 05641 / 800.636.9820 / www.thesnellgroup.com
Page
1
1. MEMORY: Insert SD memory card into the slot under the rubber cover on the side of the camera.
2. POWER: The Ti25 has an internal battery, This can be charged by plugging the adapter into the camera (under
the same rubber cover). A battery life indicator is displayed in the upper left corner of the LCD screen.
3. START: Press and hold the F2 button for 1-2 seconds until you hear an audible tone signaling camera startup.
Swing the attached lens cover up and lock in the open position on the top of the camera.
The LCD display will turn on and you will see the default start up screen (as above) showing a live
infrared image.
To turn the camera off hold the F2 button until an audible tone signals it is powering down.
4. AUTO ADJUST: (Level and Span) The default start-up mode is auto adjust and “Auto” is displayed in the upper
right corner of the LCD screen.
5. FOCUS: Focus by slowly manually rotating the focusing ring on the infrared camera lens. You may need to use
auto adjust again after focusing.
F1 F2 F3
(On/Off)
Range Indicator
Level and Span
Indicator
Memory Card Slot
Power/Charge
IR Focusing Ring
Trigger
(pause image)
Visual
Camera
(Ti10, Ti25, TiR,
TiR1 only)
Speaker
Microphone
Backlight
Battery Life
Indicator
Auto/Manual
Mode Indicator
Lens Cover
(Swing up and lock)
To Next Page
Need help?
General
