Need help?Do you have a question about the Fluke Ti450 and is the answer not in the manual?
General| Resolution | 320 x 240 pixels |
|---|---|
| Temperature Range | -20 °C to +1200 °C (-4 °F to +2192 °F) |
| Detector Type | Uncooled microbolometer |
| Operating Temperature Range | -10 °C to +50 °C (14 °F to 122 °F) |
| Focus System | LaserSharp® Auto Focus, Manual Focus |
| Image Capture Frequency | 60 Hz |
| Battery Life | Approx. 4 hours per battery |
| Display | 3.5 inch (landscape) LCD |
| Accuracy | ± 2 °C or ±2% of reading (whichever is greater) |
| Frame Rate | 60 Hz |
| Data Storage | SD Card |
| Battery Type | Rechargeable Li-ion battery |
| Storage Temperature Range | -20 °C to +50 °C without batteries |
| Spectral Range | 7.5 μm to 14 μm |
| Field of View | 24 °H x 17 °V |
Diagram and list of all external connections for the Imager.
Details the functions of the buttons on the Imager's control panel.
Describes the primary/secondary triggers and basic power-on/off operations.
Guides on how to focus the imager and capture thermal images.
Explains how to adjust the temperature range and level displayed in the image.
Guides on setting emissivity for accurate temperature measurements.
Guides on using advanced image processing features for enhanced detail.
Instructions for using the laser-assisted autofocus system.
Guides on creating a WiFi hotspot and connecting to WiFi networks.
Procedures for signing into Fluke Connect and using the mobile app.
Explains factors affecting gas leak detection and optimal conditions.
Guides on streaming live thermal video from the Imager to a PC.
Using PC or mobile device to remotely control the Imager's functions.
Guidelines for proper handling, storage, and safety of the Imager's battery.
Detailed procedures for charging the Imager's battery using different methods.
To Next Page
