We started with a passion for digital creation and a goal
to make tools for makers and designers that are easy-to-
use and affordable. After almost 2,500 backers helped
us successfully raised $1.6M on Kickstarter, it took us
a year to take FLUX Delta from prototype to a product
embraced by users around the world. Our users loved
the laser cutter on the FLUX Delta, since it enabled
them to cut and engrave materials beyond plastic, and
wanted more. In fact, one of the most frequent requests
we received from our supporters was to make the laser
engraving module more powerful. Our team plunged
deeper into the world of laser technology and decided
to take on this challenge. We gained substantial expe-
rience in manufacturing when we made a 3D printer
from scratch. Now, in pursuit of the same goal we’ve
had since day one, we’re leveraging our experience from
FLUX Delta to make something just as fantastic. Beam-
box is the laser cutter and engraver that you’ve been
waiting for, it is intuitive, intelligent, and accessible.
FLUX Team
September, 2019
PREFACE
To Next Page
Loading...
Need help?
General
