76
Close the door and press "Laser Pulse". Open the
door and check the dot on the tape. There are three
possibilities for the location of the shot:
a
The shot is in the center of the circle.
Indicating the optical path is already vertical and the
adjustment is done.
b
The dot is on the right side of the circle.
Indicating the optical path has an angle which
comes from the top-right and exit to the bottom-
left. Release all three screws counter-clockwise
half a turn to decrease the gap distance between
the metal pieces. Redo step
-
.
The dot is on the left side of the circle.
Indicating the optical path has an angle which comes
from the top-left and exit to the bottom-right. Tighten
all three screws clockwise half a turn to increase the
gap distance between the metal pieces. Redo step
-
.
Please run the "Camera Calibration" again after the
adjustment is done.
To Next Page
Loading...
Need help?
General
