17
• 5. Carefully remove the screws marked below in red.
Note: Make sure you keep the screws in a safe place.
• 6. Remove the power button cover from the front side of the system. To do so simply put the end of a
screw driver under and and gently lift it off.
• 7. Carefully pull the circuit board out and towards you.
Note: Remember that there are wires on the other side of the board. To avoid damage do not pull or put
any tension on the wires.
Note: Make sure that the wires are fitted along beside each of the gimbals as show above.
Note: Make sure that all switches are installed with the correct orientation shown above.
To Next Page
Loading...
Need help?
General
