8. FAQ
Motion shooting crosshair automatic drifting/ Air Mouse drifting under
Android mode
If you can't control the view angle by pressing LB button and shaking controller, or
the air mouse loses control, please set the controller on the table for IOS.
Firmware Update
The controller is shipped with updated firmware with stable version and there
should be no problem or any need to upgrade. Flydigi will irregularly release update
applications to enhance compatibility of product so that the controllers can perfectly
support your device. Please visit "downflydigi.com• to download update tool,
Problems with sticks or buttons
Controller can be tested in Flydigi Controller Assistant.
Stick Calibration: press and hold SELECT+START buttons for 3 seconds to enter
stick calibration, it is completed when the corresponding mode indicator will flash
slowly twice.
Failure to activate Flydigi Utool
Ifthe red indicator is always flashing, there may be a problem with the data cable
or the USB interface of the phone, Please replace and try again. (Note: some
cables may be used for charging but not for transmitting data.)
2. The blue indicator is always flashing quickly or the blue indicator is off
Make sure USB debugging is enabled on the phone (Activate Flydigi Utool-
Developer option).
3. Click 0K in the box •Allow USB Debugging
Plug the USB cable and try again
If the Red and blue indicators stay on, but it is still not activated: Please restart the
phone, wait a few minutes to try again
4, Blue indicator flashes slowly, Ensure the •Flydigi Controller Assistant is
installed; see Section 4 (Bluetooth Mode) for installation instructions
Please contact customer support with other questions.
To Next Page
Loading...
