Figure 4.4: Edit Waypoint
The waypoint may also be congured as a
Landing
, these waypoint will then be displayed in the Nearby-
Landings (see Section 4.5).
Delete Waypoint
It is possible to delete just a single waypoint on the GPS . Select the waypoint to be deleted by pressing
either the S3 or S4 buttons. Once the waypoint is highlighted, selecting
Delete Waypoint
will remove the
waypoint from the GPS memory. If a waypoint is in use int the Routethe delete function will be disabled,
to delete the Waypoint it must rstly be removed from the Route.
Delete All Waypoints
All of the waypoints can be removed from the GPS . Delete all the waypoints will also delete the Route.
When selecting this option the GPS will prompt to ensure that this is exactly what is intended.
2
Go To Point
Selecting the
Go To Point
will force navigation to the selected waypoint. Once selected (by pressing the
ENTER button), the instrument will jump to the
ight screen
automatically and navigate to that point.
When returning to the Waypoints/Routewill cancel the active
Go To
.
The
Go To
function will override the Routenavigation, although the GPS will remember where it was in
the Route, so when the
Go To
is canceled (as described above) it will resume the Routeat the point it was
at before the
Go To
was activated.
Edit Route
The GPS will only store one Route. This is deliberate to prevent ying an incorrect Route. A Routecan
be edited by selecting the
Edit Route
option of the WAM. Selecting the
Edit Route
option will highlight
the rst Routepoint in the TL area.
4.1.2 RouteList
The
RouteList
contains all the Routepoints and allows to dene their parameters in the task. Pushing the
UP or DOWN buttons will move between the Routepoints. For the highlighted
Routepoint
, the DO area
2
WARNING: Do not confuse this function with
Delete Route
. The last thing you want is to be sitting on takeo with no
waypoints in the GPS , to clear the previous Routeuse the
Delete Route
function described in section Section 4.1.2.
22
To Next Page
Loading...
