Flymaster GPS - Flight Mode

key and the S4 (Down arrow) key, simultaneously, for at least two seconds. The display will go blank and
after will return in Flight mode.
Note: Resetting the GPS will also reset ight data, e.g. task status.
1.6 Setting the Volume
The GPS sound volume can be adjust using one FS Key, or trough the Vario Accoustics option of the
Settings Menu (see Section 4.8.3). The GPS has six dierent sound levels, plus no sound . The current
volume level can be seen using the sound element (see Section 3.1.2 for more details).
Pressing the dened FS Key will scroll up the sound level until the maximum value. Pressing more will
mute the sound before start scrolling again starting from the minimum value.
Note: Changing the volume using an FS key is only valid for the current ight, and will not
override the volume level setting. Every time the instrument is turned on, if the sound is
muted, an alarm is generated in order to notify the pilot.
Note: When the instrument is turned on the sound can be muted despite the volume level
settings. This occurs due to the Auto silent mode is activated (see Section 4.8.4 for more
details)
1.7 Flight Start and Recording
Most of the GPS features are only available after the Flight Start . This procedure is taken in order to
avoid wrong calculations due to missing data. Flight starts when all of there 3 conditions are met:
1. GPS 3d x is established;
2. Speed goes over the congured Start Speed (default value is 8km/h)
3. Average vario is greater than +-0.15m/s
6