FlySky FS-MG4 - Getting Started; Transmitter Battery Installation

FS-MG4
Digital Proportional Radio Control System
4
3.Getting Started
Before operation, install the battery and connect the system as instructed below.
3.1 Transmitter Battery Installation
Danger
• Only use speci󽗉ed battery.
Danger
• Do not open, disassemble, or attempt to repair the battery.
Danger • Do not crush/puncture the battery, or short the external contacts.
Danger
• Do not expose to excessive heat or liquids.
Danger
• Do not drop the battery or expose to strong shocks or vibrations.
Danger • Always store the battery in a cool, dry place.
Danger • Do not use the battery if damaged.
Battery Type:AAA
Battery Installation:
1. Open the battery compartment cover.
2. Insert 4 fully-charged AAA batteries into the compartment. Make sure that
the battery makes good contact with the battery compartment's contacts.
3. Replace battery compartment cover.
Low battery alarm: When the battery is lower than 4.2v, the G.LED
on the panel will flash slowly.
Note: When installing the batteries, be careful to handle the positive
and negative poles. (As shown in the picture on the right)