Need help?Do you have a question about the FlySky FS-ST8 and is the answer not in the manual?
General| Brand | FlySky |
|---|---|
| Model | FS-ST8 |
| Category | Control Systems |
| Language | English |
Warnings and their meanings for safe operation.
Guidelines for safe operation and prohibited actions.
Detailed description of the FS-ST8 transmitter components.
Detailed description of the FS-SR8 receiver components and interfaces.
Information and precautions regarding transmitter antennas.
Instructions for installing batteries in the transmitter.
Guide for connecting the receiver and servos to the model.
Steps to safely power on the transmitter and receiver.
Explanation of the multi-color LED indicator and its settings.
Procedure for binding the transmitter and receiver.
Model selection, naming, copying, and resetting.
Training mode between two transmitters.
Configuring different stick modes for user preference.
System-wide settings like language, sound, LED, and display.
Setting up timers for races or usage tracking.
Assigning controls like knobs and switches to functions.
Procedure for updating the transmitter's firmware.
System info, manual access, and contact links.
Restores transmitter to factory default settings.
Settings for binding the receiver to the transmitter.
Configuration of failsafe behavior for signal loss.
Settings for displaying sensor data like voltage and signal.
Extended settings for external RF modules.
Configuration for the i-BUS serial communication protocol.
Calibrating sensor parameters for accurate data.
Settings for GPS sensor functionality and calibration.
Setting different operational conditions for a model.
Adjusting channel rates and curve for precise control.
Fine-tuning throttle output for optimal engine/motor performance.
Locking throttle output for safe operation during specific phases.
Setting up V-tail mixing for specific aircraft configurations.
Configuring delta-wing mixing for dual ailerons.
Mixing for dual tracks on models like tanks or excavators.
Adjusting helicopter pitch curve for flight control.
Specific setup for helicopter pitch control.
Setting the gyroscope function and value.
Real-time monitoring of all channel output statuses.
Reversing servo output direction for channels.
Adjusting servo travel limits (high, low, subtrim).
Adjusting output speed for specific channels.
Assigning controls to auxiliary channels (CH5-CH10).
Setting the step value for trim adjustments.
Configuring master/slave channel mixes for synchronized movement.
Important safety precautions for the receiver.
Steps to re-bind the receiver to the transmitter.
Explanation of RSSI data output and signal strength.
Procedure for updating the receiver firmware using FlyskyAssistant.
Setting failsafe modes (ON/OFF) for the receiver.
Instructions for installing throttle bracket for stick modification.
Guide for changing throttle spring for self-return functionality.
Procedure for swapping gimbals to change stick modes.
Instructions for installing the device holder.
Installing the Stealth I/O RF module adapter.
Steps for assembling the 2.4G antenna.
Technical specifications for the FS-ST8 transmitter.
Technical specifications for the FS-SR8 receiver.
Declaration of conformity for EU regulations.
Warning regarding antenna installation and RF exposure compliance.
FCC compliance statement and precautions.
To Next Page
