FlySky FS-ST8 - Getting Started; Installing Transmitter Battery; Installing Receiver and Servo

5
3. Getting Started
Danger • Do not use the battery if damaged
Battery type: AA batteries or 2S lithium batteries JST interface inside the battery compartment.
Please follow the steps below to install the transmitter batteries：
1. Openthebatterycompartmentcover.
2. Put4AAbatterieswithsu󽗋cientelectricityintothebatterycompartment.Ensurethatthemetalterminalsonthe
batteriescontactthemetalterminalsinsidethebatterycompartment.
• Oryoushouldchoosethepropersizeof2S7.4VlithiumbatterytoaccesstheJSTinterface.Connectthem
correctly.
3. Coverthebatterycompartment.
3.2 Installing Receiver and Servo
Installthereceiverandservointhefollowingmethods:
Prior to operations, please install the battery and connect devices according to the sequence and guide as
described in this chapter.
3.1 Installing Transmitter Battery
Danger
• Do not open, disassemble, or attempt to repair the battery.
Danger
• Only use speci󽗉ed battery (X4 AA batteries).
Danger
• Do not crush/puncture the battery, or short the external contacts.
Danger • Do not drop the battery or expose to strong shocks or vibrations.
Danger
• Do not expose to excessive heat or liquids
Danger
• Always store the battery in a cool, dry place.
CH1 Aileronservo
Elevatorservo
Throttleservo
Rudderservo
AUXservo
AUXservo
AUXservo
AUXservo
CH2
CH3
CH4
CH5
CH6
CH7
CH8