Focus ST-IIIB Manual

UM4""1·"6'""'
Chapter IV Voice alarm receiving
and GSM control
4.1 Remote phone control
User can remote control the system by phone ca II. after the preset ringing
times then panel will off hook the phone then enter the 4 digit user codes
according
to voice prompting and operate as per the voice prompting.
Telephone lin~
iii ~
User call landline
phones
The phone rings is 7
times, after 7 times ring
the panel will off-hook
automatically.
Please enter
password
@
ITJ0me±J
+ +
Then enter user code according
to voice prompting( the factory
default user code is 1234)
--~ Press 1 to arm system
Press 2 to disarm system
Press 3 to Stay arm
@
Press 4 to check system status
Press 5 to appliance switch contra
Press 6 to control programmable
output port
Press Oto Disconnect
4.2 Alarm receiving phone operation
When alram, the panel will dial the pre-set voice phone number, when the
user pick up the cal I, they will hear the voice prompting as below, if not press 1
to cancel the alarm or press 4 to disarm the system, after off-hook, the panel
will call other preset voice phone numbers.
«(liil>»<D .. ~ (l) ..
The panel will dial
the preset voice The user pick up
phone
number the call
when alarm occur;
~~~~~~~~~~~~~~
..lll)i\\ Play the recorded voice messa!@
"Ill!!/ first, then:
Press 1 to cancel alarm
Press
2 to check alarm event
Press 3 to arm system
Press 4 to disarm system
Press 5 to Stay arm
Press 6 to enable siren
Press 7 to listen-in
Press 8 to control programmable
output port
Press 0 to Disconnect

Focus ST-IIIB Specifications

General

Brand	Focus
Model	ST-IIIB
Category	Security System
Language	English