4.3 GSM remote operation
(talk-back
function added)
When alarm occurs, GSM will call the
preset
voice number, when
pick
up
the
call.enter
4
digit
user
code, then
voice
prompt: Press 1 to arm system,
Press 2 to disarm system, Press 3 to Stay arm, Press 4
lo
check
system
status,
Press 5 to
appliance
switch control, Press 9 to talk-back, Press 0 to
Disconnect.
4.4 GSM alarm receiving (talk-back function added)
When alarm occurs,
it
will send SMS first, then call the preset voice number,
when
pick
up the call,
ii
will play the recorded voice message first, then voice
prompt:
Press1 to cancel alarm, Press 2 to check alarm event, Press 3 to arm
system.Press 4 to disarm system, Press 5
lo
Stay
arm, Press 6
lo
enable siren,
Press 7 to listen-in, Press 8 to
control
programmable output port, Press 9 to
talk-back, Press 0 to Disconnect.
4.5 GSM control via SMS
Arm command:
password:f234syslemarml
Disamrcommand:
password:1234 system disarm
Slay
command:
password:i234systemtlome
Cancel alarm command:
[pass,.,ord:123~systelTlcanc<!iJ
Status checking command: I password:1234 system
status]
Enable programmable
output
port command:
lllaswoiiEf234pgmopen
I
Disable programmable
output
port command:. password:1234 pgm
close.
Enable appliance switch command:
switch
Disable appliance switch command:
• password: 1234 switch close
X(X=1-8
on
behalf
ofappliance
switch number)•
Setapn:
• password:1234
apn:"aaa·
Set
ID:
cpassword:T234usero"l:il:>I:>"
Set
password: I password:1234 pwd:
"ccc"
Note: the
factory
default
user
code is 1234, when arm successfully, SMS auto
reply"
arm
successfully"
,
if
the password is correct,
the
command is not
correct,
SMS will
reply"
operation
failure"
,
ifthe
password is
not
correct,
no
SMS reply.