444 9160 / 444 9180 / 442 9020
E 219 GB - Issue 1
40
11. Maintenance
Information
At normal use maintenance on the vehicle lift must be carried out once a year.
At more than average use, i.e. more than 20 lifting sessions per day, we
recommend that maintenance is done every six months in order to maintain the
safety and the value of the vehicle lift:
• Cover the spindles with grease.
• Check (or replace) gliding units of the lifting carriages for wear and tear.
• Lubricate gliding tracks of the lifting carriage gliding units.
• Grease lifting arm sections, carrying bolt and locking devices.
• Grease turntable spindles, check anti-twist devices.
• Check (or replace) rubber washer of the turntable.
• Check (replace) gliding units of the lifting arms.
• The wear and tear size between the lower edge of the cage ring and the upper edge at the shaft of
the safety nut is to be checked.
• Check (or replace) function and condition of the locking devices of the lifting arms.
• Check the function of the analogue path measuring initiator.
• Check initial tension and condition of the ribbed V-belts, adjust tension and, if necessary, replace them.
• Check all screw connections.
• Check the dowel connection with a torque wrench.
The exchange of load bearing parts and control components must always carried out by an expert to ensure
that the stipulated values, which are necessary for perfect operating of the vehicle lift, are adhered to.
Otherwise the life span of the exchanged parts and the overall function would be limited.
For statutory inspections we recommend entering into a maintenance
contract (safety checks and maintenance) with one of our authorised customer
service partners. Only he may enter test results into the record book and present
you with an “HAK” test plaque which confirms the safety and functioning of the
vehicle lift.
Information
To Next Page
Loading...