Marinating
with
your
FoodSaver
Appliance
For
use
with
Foodsaver®
Smartseaf
Technology
(V3000
Series) Models
Your FoodSaver*'
Vacuum
Sealing
System
has
a
special Quick Marinate Cycle which will last
about
ten
minutes.
The
vacuum
motor
will
"hold"
the
vacuum
for
several
minutes
then
release
the
vacuum
allowing
the
food to
"rest"
for 30
seconds.
This
process
will
then
repeat
two
more
times.
This
"Pulsing"
action
of
"vacuuming
and
resting"
will allow for
quicker
marinating. When
the
Quick
Marinate Cycle is
completed
the
appliance
will
beep
to
signal
marinating
is
complete.
The
FoodSaver"
Quick
Marinator
Canister
is
the perfect FoodSaver® Accessory for marinating
foods.
Foods
will
marinate
in
minutes
when
vacuum
packaged
because
the vacuum
process
opens
the
pores
of
the
food and
absorbs
the
marinade
more
quickly.
Important Note: During the Quick Marinate Cycle,
make
sure
knob on accessory lid is
set
to
OPEN.
Donot set knob to Vacuum. TheVacuum position
on the knob will allow the Quick Marinating
Canister
to be
used
for
extending
vacuum
storage.
1. Prepare
enough
of your favorite
marinade
to fully
cover food inside a marinating canister. Always
leave at
least
one
inch of
space
between
contents
and top of rim.
2. Make sure rubber gasket underneath the lid as
well as rim of marinating canister is free from
food
materials.
3. Make
sure
Accessory Hose is securely inserted
into port on the
FoodSaver®
Quick Marinator lid.
4. Make sure knob on accessory lid is set to the
OPEN/MARINATE
position.
5. Makesure lid is firmlyattached to marinator base.
6. Press Marinate button 3 on the control panel.
7. Your FoodSaver® Vacuum
Sealing
System
will now begin the Quick Marinate Cycle. The
Marinate
Indicator
Light will flash to
indicate
the
marinating
process
has
begun.
8. During
the
initial vacuum cycle
the
Marinate
Mode
Indicator
will
illuminate.
While
Marinating,
the
Vacuum Meter Display will blink during
the
Vacuum Hold or Rest Cycle.
9. To
preserve
food
safely,
after
completing
the
marinating
cycle,
the
appliance
will
signal
with
short
beeps
to
indicate
your Quick
Marinate
Cycle is
completed.
Press
any
button
to
silence
the
signal.
You may now cook or refrigerate your marinated food.
For
Use
With
All
Other
Foodsaver
Vacuum
Sealing
Appliance
Models
. Prepare enough of your favorite marinade to fully
cover food inside a marinating canister. Always
leave at one inch of
space
between
contents
and
top of rim.
. Make
sure
rubber
gasket
underneath
the lid as
well as rim of marinating
canister
is free from
food
materials.
. Insert one end of the Accessory Hose into the
Accessory Port on your FoodSaver® appliance.
. Make
sure
Accessory Hose is securely
inserted
into port on the FoodSaver® Quick Marinator lid.
To Next Page
Loading...
