16
If you do not want to set an alarm, press SET to skip this step.
If you want to turn off an alarm, find the alarm number by pressing
SET in the setting mode, press
to change from “ONʼ to “OFF”.
At the time of your alarm, the
meter will beep and automati-
cally turn on. You can press
to
silence the alarm and insert a test
strip to begin testing.
If you do not press
, the meter will beep for 2 minutes then
switch off.
If you do not want to test at this time, press
to switch off the
meter.
NOTE
• These parameters can ONLY be changed in the setting mode.
• If the meter is idle for 3 minutes during the setting mode, it will switch off
automatically.
Congratulations! You have completed all settings!
To Next Page
Loading...
