EasyManua.ls Logo

Force 10 Galley - Trouble Shooting Guide

Force 10 Galley
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 12 of 15
TROUBLE SHOOTING GUIDE
PROBLEM CAUSE Solution______________
Burner will not stay lit
Thermocouple is not in the
flame
See Low Flame
Thermocouple has failed Replace thermocouple
Solenoid in the valve has
failed
Replace solenoid
Burner will not light
(No gas)
Supply tank is empty Re-fill tank
Shut-off valve is closed Open valve
System Solenoid is shut Reset or replace
Air lock in fuel line Bleed the fuel line
Blocked orifice Remove and clean orifice
Low Flame
Low gas pressure Check regulator at the tank
Dirty orifice Remove and clean orifice
Igniter does not spark
Battery is dead Change battery
Spark plug is dirty Clean tip of spark plug
Spark Box has failed Replace the spark box
Oven does not get hot
The heat plate is not
installed
Install the heat plate
Dirty orifice Remove and clean orifice
Low gas pressure Check regulator at the tank